Modulab High Flow System Bio Model
The MODULAB® High Flow water system is a modular, point-of-use polishing system which consistently provides high quality Type 1 water (up to 18.2 Mω cm @ 25 °C) with flow rates up to 14 lpm (3.7 gpm) of pretreated water. The MODULAB High Flow system is a wall- mountable unit that requires a minimal footprint for installation.
Description
The MODULAB High Flow is delivered fully assembled and functionally tested. Cartridges will need to be purchased separately and should be installed after the system has been safely mounted. The system is offered in three configurations:
- a low TOC model
- a low bacteria model
- a low pyrogen model
Features
LEGACY MATERIAL ID
MHF0SMF2
PRODUCT FEATURES
- High capacity, low TOC cartridges
- Flow rates up to 14 lpm
- Dual wavelength UV sterilization
- Wall mountable
- Up to 18.2 Megohm-cm water
- Choice of cartridge to fit your application
- Easy Sanitization
TECHNICAL DATA
- Minimum Flow Rate: 2 lpm (0.5 gpm)
- Maximum Flow Rate: 14 lpm (3.7 gpm)
- Product Water Resistivity: Up to 18.2 Megω-cm @ 25 °C
- Total Organic Carbon (TOC): < 15 ppb *
- Heavy Metals: < 0.01 ppb
- Bacteria: < 10 cfu/ml **
- Endotoxin: < 0.05 EU/ml ***
With Organic Removal Cartridge installed and RO (reverse osmosis) feed water.
** With Sub-micron filter installed as specified.
*** With UF (ultrafiltration) Filter Cartridge installed as specified. Note: Specifications are based on a RO feed.
GENERAL SPECIFICATIONS
- Minimum Feed Pressure: 25 psig
- Maximum Feed Pressure: 60 psig
- Minimum Feed Temperature: 41 °F (5 °C)
- Maximum Feed Temperature: 86 °F (30 °C)
PHYSICAL SPECIFICATIONS
- Length: 43" (109 cm)
- Depth: 8.5" (22 cm)
- Height: 39" (100 cm)*
- UV Bulb Service Clearance: 6" (16 cm)
- Front *Requires an additional 4" in height to allow changing of cartridges
ELECTRICAL REQUIREMENTS
- Low voltage service, single phase, 120VAC
- 15 AMP breaker required by code
- Feed Water Requirement
- RO or DI feed water required
