Description
The MODULAB® High Flow water system is a modular, point-of-use polishing system which consistently provides high quality Type 1 water (up to 18.2 Mω cm @ 25 °C) with flow rates up to 14 lpm (3.7 gpm) of pretreated water. The MODULAB High Flow system is a wall- mountable unit that requires a minimal footprint for installation.
Description
The MODULAB High Flow is delivered fully assembled and functionally tested. Cartridges will need to be purchased separately and should be installed after the system has been safely mounted. The system is offered in three configurations:
- a low TOC model
- a low bacteria model
- a low pyrogen model
Features
LEGACY MATERIAL ID
MHF0SMF2
PRODUCT FEATURES
- High capacity, low TOC cartridges
- Flow rates up to 14 lpm
- Dual wavelength UV sterilization
- Wall mountable
- Up to 18.2 Megohm-cm water
- Choice of cartridge to fit your application
- Easy Sanitization
TECHNICAL DATA
- Minimum Flow Rate: 2 lpm (0.5 gpm)
- Maximum Flow Rate: 14 lpm (3.7 gpm)
- Product Water Resistivity: Up to 18.2 Megω-cm @ 25 °C
- Total Organic Carbon (TOC): < 15 ppb *
- Heavy Metals: < 0.01 ppb
- Bacteria: < 10 cfu/ml **
- Endotoxin: < 0.05 EU/ml ***
With Organic Removal Cartridge installed and RO (reverse osmosis) feed water.
** With Sub-micron filter installed as specified.
*** With UF (ultrafiltration) Filter Cartridge installed as specified. Note: Specifications are based on a RO feed.
GENERAL SPECIFICATIONS
- Minimum Feed Pressure: 25 psig
- Maximum Feed Pressure: 60 psig
- Minimum Feed Temperature: 41 °F (5 °C)
- Maximum Feed Temperature: 86 °F (30 °C)
PHYSICAL SPECIFICATIONS
- Length: 43″ (109 cm)
- Depth: 8.5″ (22 cm)
- Height: 39″ (100 cm)*
- UV Bulb Service Clearance: 6″ (16 cm)
- Front *Requires an additional 4″ in height to allow changing of cartridges
ELECTRICAL REQUIREMENTS
- Low voltage service, single phase, 120VAC
- 15 AMP breaker required by code
- Feed Water Requirement
- RO or DI feed water required
High-flow polishing of pretreated RO or DI water
The published Applied Physics MODULAB High Flow specifications describe a wall-mountable polishing platform for RO or DI feedwater. Cartridge and final-filter selection determine the targeted organic, bacterial or pyrogen performance.
Low TOC
High-capacity organic-removal cartridge configurations target lower TOC where required.
Low bacteria
Final filtration and system configuration are selected around the microbial specification.
Low pyrogen
Ultrafiltration configuration can be selected for applications with endotoxin requirements.
Questions engineers and validation teams ask
What is the MODULAB High Flow Bio Model?
It is a modular point-of-use polishing system for pretreated RO or DI feedwater, with published flow from 2 to 14 L/min and water resistivity up to 18.2 MΩ·cm at 25 °C.
Does MODULAB High Flow require pretreated feedwater?
Yes. The published Applied Physics specification calls for RO or DI feedwater. Cartridge and final-filter configuration determine the targeted TOC, bacteria or pyrogen performance.






Reviews
There are no reviews yet.