Description
The MODULAB High Flow water system is a modular, point-of-use polishing system which consistently provides high quality Type 1 water (up to 18. 2 M& omega; cm @ 25 C) with flow rates up to 14 lpm (3. 7 gpm) of pretreated water. Material: W2T196103 Unit of Measure #: EA
Offer in three configurations:
- Low TOC model
- Low bacteria model
- Low pyrogen model
Description
The MODULAB High Flow system is a wall-mountable unit that requires a minimal footprint for installation. The MODULAB High Flow is delivered fully assembled and functionally tested. Cartridge will need to be purchased separately and should be installed after the system has been safely mounted.
Product Information
Legacy Part Number
MHF0ORG1
Features and Benefits
- High capacity, low TOC cartridge
- Flow rates up to 14 lpm
- Dual wavelength UV sterilization
- Wall mountable Up to 18.2 Megohm-cm water
- Choice of Cartridge to fit your application
- Easy Sanitization
Specification
- Minimum Flow Rate: 2 lpm (0. 5 gpm)
- Maximum Flow Rate: 14 lpm (3. 7 gpm)
- Product Water Resistivity: Up to 18. 2 Meg & omega;-cm @ 25 C
- Total Organic Carbon (TOC): < 15 ppb *
- Heavy Metals: < 0.01 ppb
- Bacteria: < 10 cfu/ml **
- Endotoxin: < 0.05 EU/ml ***
* With Organic Removal Cartridge installed and RO (reverse osmosis) feed water.
** With Sub-micron filter installed as specified.
*** With UF (ultrafiltration) Filter Cartridge installed as specified.
Note: Specifications are based on a RO feed.
General Specifications
- Minimum Feed Presure: 25 psig
- Maximum Feed Pressure: 60 psig
- Minimum Feed Temperature: 41 F (5 C)
- Maximum Feed Temperature: 86 F (30 C)
Physical Specifications
- Length: 43″ (109 cm)
- Depth: 8. 5″ (22 cm)
- Height: 39″ (100 cm)*
- UV Bulb Service Clearance: 6″ (16 cm) Front
*Requires an additional 4″ in height to allow changing of Cartridge
Electrical Requirements
- Low voltage service, single phase, 120VAC
- 15 AMP breaker required by code
Feed Water Requirements
- RO or DI feed water required
High-flow polishing of pretreated RO or DI water
The published Applied Physics MODULAB High Flow specifications describe a wall-mountable polishing platform for RO or DI feedwater. Cartridge and final-filter selection determine the targeted organic, bacterial or pyrogen performance.
Low TOC
High-capacity organic-removal cartridge configurations target lower TOC where required.
Low bacteria
Final filtration and system configuration are selected around the microbial specification.
Low pyrogen
Ultrafiltration configuration can be selected for applications with endotoxin requirements.
Questions engineers and validation teams ask
What flow range does the MODULAB High Flow system support?
The published Applied Physics specification lists a minimum flow of 2 L/min and maximum flow of 14 L/min, with product-water resistivity up to 18.2 MΩ·cm at 25 °C.
What feedwater does MODULAB High Flow require?
The system requires RO or DI feedwater. Final water characteristics depend on the installed cartridge and filter configuration.






Reviews
There are no reviews yet.